This rollerbearing tailshaft housing is designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock, yet weighs only 4-1/2 pounds
- Bolt in replacement - length and crossmember mounting flange is exactly the same as stock
- Needle roller bearing transfers maximum horsepower
- Triple lip seal
- Spiral retaining ring to prevent bearing walk
- Relocated vent puts an end to the problem of trans fluid spraying out of breather
- Completely pre-assembled
- Includes a hardware kit with everything you need to bolt it on
Special Note: No speedometer cable provision is supplied and due to the precise dimension of the needle bearing, some yokes may need polishing to fit correctly. Accepts 1.497" - 1.499" O.D. yokes. Some yokes are produced at 1.502" to compensate for bushing wear. MEASURE YOURS!
